Power Wheelchair Pride Jazzy 623 Mid Wheel Drive (Swl 136Kg) [J623]
$8,453
- Mid-Wheel 6® allows six wheels on the ground for maximum stability
- Compatible with TRU-Balance® Power Positioning
- Low impact OMNI-Casters (nylon, spherical-shaped castors) on front and rear prevent wheel hang-ups
- ATX Suspension (Active-Trac® with extra stability) incorporates front OMNI-Castors and semi-independent rear castor beam for enhanced performance over more varied terrain
- Solid tyres
- Cup holder
- Swing-away footrests
- Swing-away joystick
- Elevating leg rests
- Oxygen tank holder
- TB2 Tilt and Synergy® Seat
- Cane/crutch holder
- Walker holder
- Contoured high-back seat
- Synergy® Seat
- Specialty Seat
- TRU-Comfort seating
- Weight capacity - 136 kg (300 lbs.)
- Maximum speed 1 - Up to 8 km/h (5 mph)
- Ground clearance 2 - 6.35 cm (2.5”) at front castor
- Turning radius 2,6 - 7.62 cm (3”) at rear castor
- Overall length 2,6 - 50.8 cm (20”) 7
- Overall width 2,6 - 90.17 cm (35.5”) 7
- Drive wheels - 61 cm (24”)
- Front castors - 35.56 cm (14”) (pneumatic)
- Rear castors - 15.25 cm (6”) solid OMNI-casters
- Suspension - Active-Trac® ATX Suspension
- Drivetrain - Two-motor, Mid-Wheel 6®
- Braking system - Intelligent braking (electronic, regenerative disc brakes)
- Standard electronics - 75 amp, Dynamic Shark controller
- Standard seat - high-back seat
- Specialty controls - Yes
- Battery charger - Off-board, 8 amp
- Per-charge range 1,4 - Up to 25.6 km (15.9 miles)
- Battery requirements 3 - (2) 12 volt deep-cycle
- Battery size (largest) - 55 AH
- Battery weight 5 - 17.7 kg (39 lbs.) each
- Base weight - 62 kg (137.5 lbs.) (without batteries)
- Standard seat weight - 20 kg (44 lbs.) (high-back)
- Std. seating dimensions - 45.7 cm x 45.7 cm (18” x 18”)
- Varies with base model, user weight, terrain type, battery amp hour rating (AH), battery charge, battery condition, motors, controller type, tyre type, and tyre condition. This specification is subject to a variance of +10%, -5%.
- Due to manufacturing tolerances and continued product improvement, this specification can be subject to a variance of (+ or -) 3%.
- AGM or gel cell type required.
- Tested in accordance with ANSI/RESNA, WC Vol 2, Section 4 & ISO 7176-4 standards. Results derived from theoretical calculations based on battery specifications and drive system performance. Test conducted at maximum weight capacity.
- Battery weight may vary based on manufacturer.
- Dimensions listed are for power base only. Overall measurements will vary based on seating and accessory selections.
- Without foot riggings.